Clixon yang routing example

Compile and run

    cd example
    make && sudo make install

Start backend:

    clixon_backend -f /usr/local/etc/routing.conf -I

Edit cli:

    clixon_cli -f /usr/local/etc/routing.conf

Send netconf command:

    clixon_netconf -f /usr/local/etc/routing.conf

Setting data example using netconf

<rpc><edit-config><target><candidate/></target><config>
      <interfaces>
         <interface>
            <name>eth1</name>
            <enabled>true</enabled>
            <ipv4>
               <address>
                  <ip>9.2.3.4</ip>
                  <prefix-length>24</prefix-length>
               </address>
            </ipv4>
         </interface>
      </interfaces>
</config></edit-config></rpc>]]>]]>

Getting data using netconf

<rpc><get-config><source><candidate/></source></get-config></rpc>]]>]]>
<rpc><get-config><source><candidate/></source><filter/></get-config></rpc>]]>]]>
<rpc><get-config><source><candidate/></source><filter type="xpath"/></get-config></rpc>]]>]]>
<rpc><get-config><source><candidate/></source><filter type="subtree"><configuration><interfaces><interface><ipv4/></interface></interfaces></configuration></filter></get-config></rpc>]]>]]>
<rpc><get-config><source><candidate/></source><filter type="xpath" select="/interfaces/interface/ipv4"/></get-config></rpc>]]>]]>
<rpc><validate><source><candidate/></source></validate></rpc>]]>]]>

Creating notification

The example has an example notification triggering every 10s. To start a notification stream in the session, create a subscription:

<rpc><create-subscription><stream>ROUTING</stream></create-subscription></rpc>]]>]]>
<rpc-reply><ok/></rpc-reply>]]>]]>
<notification><event>Routing notification</event></notification>]]>]]>
<notification><event>Routing notification</event></notification>]]>]]>
...

This can also be triggered via the CLI:

cli> notify 
cli> Routing notification
Routing notification
...

Extending

Clixon has an extension mechanism which can be used to make extended internal netconf messages to the backend configuration engine. You may need this to make some special operation that is not covered by standard netconf functions. The example has a simple "echo" downcall mechanism that simply echoes what is sent down and is included for reference. A more realistic downcall would perform some action, such as reading some status.

Example:

cli> downcall "This is a  string"
This is a string

Run as docker container

cd docker
# look in README

2.5 KiB Raw Blame History