#
# ***** BEGIN LICENSE BLOCK *****
# 
# Copyright (C) 2009-2017 Olof Hagsand and Benny Holmgren
#
# This file is part of CLIXON
#
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at
#
#   http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.
#
# Alternatively, the contents of this file may be used under the terms of
# the GNU General Public License Version 3 or later (the "GPL"),
# in which case the provisions of the GPL are applicable instead
# of those above. If you wish to allow use of your version of this file only
# under the terms of the GPL, and not to allow others to
# use your version of this file under the terms of Apache License version 2, 
# indicate your decision by deleting the provisions above and replace them with
# the notice and other provisions required by the GPL. If you do not delete
# the provisions above, a recipient may use your version of this file under
# the terms of any one of the Apache License version 2 or the GPL.
#
# ***** END LICENSE BLOCK *****
#

#
# Include this file in your application Makefile using eg:
# -include $(datarootdir)/clixon/clixon.mk
# then you can use the DIRS below in your install rules.
# You also get rules for the application configure file.
# NOTE: APPNAME must be defined in the local Makefile

clixon_DBSPECDIR=prefix/share/$(APPNAME)
clixon_SYSCONFDIR=sysconfdir
clixon_LOCALSTATEDIR=localstatedir/$(APPNAME)
clixon_LIBDIR=libdir/$(APPNAME)
clixon_DATADIR=datadir/clixon

# Rules for the clixon application configuration file.
# The clixon applications should be started with this fileas its -f argument.
# Typically installed in sysconfdir
# Example: APPNAME=myapp --> clixon_cli -f /usr/local/etc/myapp.conf
# The two variants are if there is a .conf.local file or not
.PHONY: $(APPNAME).conf
ifneq (,$(wildcard ${APPNAME}.conf.local)) 	
${APPNAME}.conf:  ${clixon_DATADIR}/clixon.conf.cpp ${APPNAME}.conf.local
	$(CPP) -P -x assembler-with-cpp -DAPPNAME=$(APPNAME) $< > $@
	cat ${APPNAME}.conf.local >> $@
else
${APPNAME}.conf:  ${clixon_DATADIR}/clixon.conf.cpp
	$(CPP) -P -x assembler-with-cpp -DAPPNAME=$(APPNAME) $< > $@
endif